Configuring Server Load Balancing Configuring the Server Farm
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 44-15
4 Select Internet Protocol (TCP/IP) in the Microsoft Loopback Adapter Properties window.
5 Click the Properties button.
6 Click the Use the following IP address radio button in the Internet Properties (TCP/IP) Properties
window.
7 Enter the Virtual IP (VIP) address in the IP Address window.
Note. Use the same subnet mask as for the physical IP interface.
8 Click the OK button.
Select “Internet Protocol
(TCP/IP)”.
Click the “Properties” button.
Enter the VIP
address here.
Click “OK” when
done.
Select “Use the following
IP address” radio button.
To Next Page
Loading...
