Diagnosing Switch Problems sFlow Overview
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 45-9
For more information about this command, see “sFlow” on page 45-29 or the “sFlow Commands” chapter
in the OmniSwitch CLI Reference Guide.
Follow the steps below to create a sFlow poller session.
1 To create a sFlow poller session, use the sflow poller command by entering sflow
poller, followed by the instance ID, port list, receiver, and the interval. For example:
-> sflow poller 1 2/6-10 receiver 1 interval 30
Note. Optional. To verify the sFlow poller configuration, enter show sflow poller, followed by the sFlow
poller instance ID. The display is similar to the one shown below:
-> show sflow poller
Instance Interface Receiver Interval
-------------------------------------------
1 2/ 6 1 30
1 2/ 7 1 30
1 2/ 8 1 30
1 2/ 9 1 30
1 2/10 1 30
For more information about this command, see “sFlow” on page 45-29 or the “sFlow Commands” chapter
in the OmniSwitch CLI Reference Guide.
To Next Page
Loading...
