Index
Index-8 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Internal Spanning Tree (IST) Instance 12-9
Interoperability 12-12
Migration 12-12, 12-13
MSTI 12-7
application example 12-16
MSTP 12-4
Multiple Spanning Tree Region 12-8
Multicast Listener Discovery (MLD) 42-25
Multiple Spanning Tree
defaults 13-5
N
netsec group anomaly command 47-3
netsec group port command 47-3
network address VLAN rules 8-6
Network Security
application examples 47-3
defaults 47-2
non combo ports
configuring 1-16
Novell
IPX 33-1
O
OSPF 28-4
defaults 27-3, 30-3
graceful restart on switches 10-14
loading software 30-13
specifications 27-2, 30-2
OSPF redistribution policies
deleting 24-19, 24-21, 26-22, 26-24, 28-16
P
pending configuration 40-54
pending policies
deleting 40-55
testing 40-39
Per VLAN DHCP 31-9
PIM-SM 42-8
ping
IP 24-32
IPX 33-10
ping command 24-32
ping ipx command 33-10
policies
application examples 40-57
applied 40-54
built-in 40-12
conditions 40-33
creating policy actions 40-34
how the switch uses them 40-4
Policy Based Routing 40-62
precedence 40-37, 41-6
redirect linkagg 40-59
redirect port 40-59
rules 40-35
verify information about 40-38
policies configured via PolicyView 40-56
policy
for ACLs 41-11
policy actions 41-10
policy conditions 41-9
policy rule 41-11
policy action 802.1p command 40-29
policy action command 40-24, 40-31
policy action map command 40-51
policy action redirect linkagg command 40-59
policy action redirect port command 40-59, 40-60
policy actions
see actions
Policy Based Routing 40-62
policy condition command 40-31
policy conditions
see conditions
policy mac group command 40-42, 41-8
policy MAC groups 40-46
policy map group command 40-51
policy map groups
application example 40-51
policy network group command 40-42, 41-8
policy network groups 40-43
switch default group 40-12, 40-43
policy port group command 40-42, 41-8
policy port groups 40-47
policy rule command 40-31
policy server command 38-2, 38-4
policy server flush command 38-6
compared to
qos flush command 38-7
policy server load command 38-6
policy servers
defaults 38-2
downloading policies 38-6
installing 38-3
SSL 38-6
policy service command 41-8
policy service group command 40-42, 41-8
policy service groups 40-45
policy services 40-44
PolicyView
LDAP policy servers 38-1
Port Based Network Access Control
see 802.1X
Port Mapping 7-1
application examples 7-2, 7-6
defaults 7-2
specifications 7-2
port mapping command 7-2
Port Mapping Session
creating and deleting 7-3
enabling and disabling 7-4
port mirroring 45-14
application examples 45-4
defaults 45-3
direction 45-20
disabling mirroring status 45-19
displaying status 45-21
To Next Page
Loading...
