Alcatel-Lucent OmniSwitch 6850-48 - Page 16

Contents
xvi OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Chapter 20 Using Interswitch Protocols ...................................................................................20-1
In This Chapter ..............................................................................................................20-1
AIP Specifications .........................................................................................................20-2
AMAP Defaults ............................................................................................................20-2
AMAP Overview ..........................................................................................................20-3
AMAP Transmission States ...................................................................................20-3
Discovery Transmission State .........................................................................20-4
Common Transmission State ...........................................................................20-4
Passive Reception State ...................................................................................20-4
Common Transmission and Remote Switches .......................................................20-5
Configuring AMAP .......................................................................................................20-5
Enabling or Disabling AMAP ................................................................................20-5
Configuring the AMAP Discovery Time-out Interval ...........................................20-5
Configuring the AMAP Common Time-out Interval .............................................20-6
Displaying AMAP Information ..............................................................................20-7
Chapter 21 Configuring 802.1Q .................................................................................................21-1
In this Chapter ...............................................................................................................21-1
802.1Q Specifications ...................................................................................................21-2
802.1Q Defaults Table ..................................................................................................21-2
802.1Q Overview ..........................................................................................................21-3
Configuring an 802.1Q VLAN .....................................................................................21-5
Enabling Tagging on a Port ....................................................................................21-5
Enabling Tagging with Link Aggregation .............................................................21-5
Configuring the Frame Type ..................................................................................21-6
Show 802.1Q Information ......................................................................................21-7
Application Example .....................................................................................................21-8
Verifying 802.1Q Configuration .................................................................................21-10
Chapter 22 Configuring Static Link Aggregation ..................................................................22-1
In This Chapter ..............................................................................................................22-1
Static Link Aggregation Specifications ........................................................................22-2
Static Link Aggregation Default Values .......................................................................22-2
Quick Steps for Configuring Static Link Aggregation .................................................22-3
Static Link Aggregation Overview ...............................................................................22-5
Static Link Aggregation Operation ........................................................................22-5
Relationship to Other Features ...............................................................................22-6
Configuring Static Link Aggregation Groups ...............................................................22-7
Configuring Mandatory Static Link Aggregate Parameters ...................................22-7
Creating and Deleting a Static Link Aggregate Group ..........................................22-8
Creating a Static Aggregate Group ..................................................................22-8
Deleting a Static Aggregate Group ..................................................................22-8