Alcatel-Lucent OmniSwitch 6850-48 - Page 246

MPLS Application Example Configuring MPLS
page 10-38 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
-> configure service vpls 100 sap 1/15 create
-> configure service vpls 100 sap 1/15 no shutdown
-> configure service port 1/3 mode access
-> configure service vpls 100 sap 1/3 create
-> configure service vpls 100 sap 1/3 no shutdown
Router 3
1 Create SDP 20 and associate the SDP with the “to-R2” and “to-R2-alt” static LSP tunnels.
-> configure service sdp 20 create
-> configure service sdp 20 signaling off
-> configure service sdp 20 no ldp
-> configure service sdp 20 far-end 10.10.10.1
-> configure service sdp 20 no shutdown
-> configure service sdp 20 lsp to-R2
-> configure service sdp 20 lsp to-R2-alt
2 Create SDP 30 and associate the SDP with the “to-R4” and “to-R4-alt” static LSP tunnels.
-> configure service sdp 30 create
-> configure service sdp 30 signaling off
-> configure service sdp 30 no ldp
-> configure service sdp 30 far-end 10.1.1.3
-> configure service sdp 30 no shutdown
-> configure service sdp 30 lsp to-R4
-> configure service sdp 30 lsp to-R4-alt
3 Create SDP 40 for use with LDP-enabled LSP between R3 and R4.
-> configure service sdp 40 mpls create
-> configure service sdp 40 far-end 10.1.1.3
-> configure service sdp 40 no shutdown
4 Create VPLS 100 and associate the service with the Customer 1 account.
-> configure service customer 1 create
-> configure service vpls 100 customer 1 create
5 Bind VPLS 100 with SDP 20 and SDP 30.
-> configure service vpls 100 mesh-sdp 20 create
-> configure service vpls 100 mesh-sdp 20 ingress vc-label 2222
-> configure service vpls 100 mesh-sdp 20 egress vc-label 3333
-> configure service vpls 100 mesh-sdp 20 no shutdown
-> configure service vpls 100 mesh-sdp 30 create
-> configure service vpls 100 mesh-sdp 30 ingress vc-label 2223
-> configure service vpls 100 mesh-sdp 30 egress vc-label 3334
-> configure service vpls 100 mesh-sdp 30 no shutdown
-> configure service vpls 100 no shutdown
6 Create a SAP on access ports 1/8 and 1/7 and associate the SAP with VPLS 100.
-> configure service port 1/8 mode access
-> configure service vpls 100 sap 1/8 create
-> configure service vpls 100 sap 1/8 no shutdown