Using 802.1Q 2005 Multiple Spanning Tree Quick Steps for Configuring an MST Region
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 12-15
3 Map VLANs 100 and 200 to MSTI 2 and VLANs 300 and 400 to MSTI 4 using the bridge msti vlan
command to define the configuration digest. For example:
-> bridge msti 2 vlan 100 200
-> bridge msti 4 vlan 300 400
See “Quick Steps for Configuring MSTIs” on page 12-16 for a tutorial on how to create and map
MSTIs to VLANs.
4 Configure 3 as the maximum number of hops for the region using the bridge mst region max hops
command. For example:
-> bridge mst region max hops 3
Note. (Optional) Verify the MST region configuration on each switch with the show spantree mst region
command. For example:
-> show spantree mst region
Configuration Name : Alcatel Marketing,
Revision Level : 2000,
Configuration Digest : 0x922fb3f 31752d68 67fe1155 d0ce8380,
Revision Max hops : 3,
Cist Instance Number : 0
All switches configured with the exact same values as shown in the above example are considered
members of the Alcatel-Lucent Marketing MST region.
To Next Page
Loading...
