Modifying Dynamic Link Aggregate Group Parameters Configuring Dynamic Link Aggregation
page 23-28 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
For example, to modify the port priority of dynamic aggregate partner port 3 in slot 4 to 100 you would
enter:
-> lacp agg 4/3 partner admin port priority 100
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation
Alcatel-Lucent CLI syntax. For example, to modify the port priority of dynamic aggregate partner port 3
in slot 4 to 100 and document that the port is a Giga Ethernet port you would enter:
-> lacp agg gigaethernet 4/3 partner admin port priority 100
Restoring the Partner Port Priority
To remove a user-configured partner port priority from a dynamic aggregate group partner port’s configu-
ration use the no form of the lacp agg partner admin port priority command by entering lacp agg, the
slot number, a slash (/), the port number, and no partner admin port priority.
For example, to remove a user-configured partner port priority from dynamic aggregate partner port 3 in
slot 4 you would enter:
-> lacp agg 4/3 no partner admin port priority
To Next Page
Loading...
