Configuring Dynamic Link Aggregation Displaying Dynamic Link Aggregation Configuration and Statistics
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 23-33
A screen similar to the following would be displayed:
Dynamic Aggregable Port
SNMP Id : 2001,
Slot/Port : 2/1,
Administrative State : ENABLED,
Operational State : DOWN,
Port State : CONFIGURED,
Link State : DOWN,
Selected Agg Number : NONE,
Primary port : UNKNOWN,
LACP
Actor System Priority : 10,
Actor System Id : [00:d0:95:6a:78:3a],
Actor Admin Key : 8,
Actor Oper Key : 8,
Partner Admin System Priority : 20,
Partner Oper System Priority : 20,
Partner Admin System Id : [00:00:00:00:00:00],
Partner Oper System Id : [00:00:00:00:00:00],
Partner Admin Key : 8,
Partner Oper Key : 0,
Attached Agg Id : 0,
Actor Port : 7,
Actor Port Priority : 15,
Partner Admin Port : 0,
Partner Oper Port : 0,
Partner Admin Port Priority : 0,
Partner Oper Port Priority : 0,
Actor Admin State : act1.tim1.agg1.syn0.col0.dis0.def1.exp0,
Actor Oper State : act1.tim1.agg1.syn0.col0.dis0.def1.exp0,
Partner Admin State : act0.tim0.agg1.syn1.col1.dis1.def1.exp0,
Partner Oper State : act0.tim0.agg1.syn0.col1.dis1.def1.exp0
Note. See the “Link Aggregation Commands” chapter in the OmniSwitch CLI Reference Guide for
complete documentation of show commands for link aggregation.
To Next Page
Loading...
