Configuring IP IP Forwarding
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 24-15
Up to 200 ARP filters can be defined on a single switch. To remove an individual filter, use the no form of
the arp filter command. For example:
-> no arp filter 198.0.0.0
To clear all ARP filters from the switch configuration, use the clear arp filter command. For example:
-> clear arp filter
Use the show arp summary command to verify the ARP filter configuration. For more information about
this and other ARP filter commands, see the OmniSwitch CLI Reference Guide.
To Next Page
Loading...
