Quick Steps for Configuring RDP Configuring RDP
page 29-4 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
To verify the configuration for a specific RDP interface, specify the interface name when using the show
ip router-discovery interface command. The display is similar to the one shown below:
-> show ip router-discovery interface Marketing
Name = Marketing,
IP Address = 11.255.4.1,
IP Mask = 255.0.0.0,
IP Interface status = Enabled,
RDP Interface status = Enabled,
VRRP Interface status = Disabled,
Advertisement address = 224.0.0.1,
Max Advertisement interval = 600 secs,
Min Advertisement interval = 450 secs,
Advertisement lifetime = 1800 secs,
Preference Level = 0x0,
#Packets sent = 3,
#Packets received = 0
For more information about this command, refer to the “RDP Commands” chapter in the OmniSwitch CLI
Reference Guide.
To Next Page
Loading...
