Configuring Ethernet Ports Setting Ethernet Parameters for All Port Types
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 1-15
To enable the DDM capability on the switch use the interfaces transceiver ddm command. For example,
enter:
-> interfaces transceiver ddm enable
Traps can be enabled if any of these above values crosses the pre-defined low or high thresholds of the
transceiver. For example, to set the maximum frame size on port 3 on slot 2 to 9216 bytes, enter:
-> interfaces transceiver ddm trap enable
Note: In order to take advantage of the DDM capability, the transceiver must support the DDM function-
ality. Not all transceivers support DDM, refer to the Transceivers Guide for additional DDM information.
To Next Page
Loading...
