Configuring VRRP VRRP Configuration Overview
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 32-17
Note. You can specify a parameter such as interval, priority, preempt or all in the vrrp group set
command to set and/or override the existing value with the new default values. By default the option all is
applied. The all option resets and/or overrides the existing advertising interval value, priority value and
preempt mode with the modified default values.
The next command enables all the virtual routers in the group except the virtual routers that are disabled
individually. To enable all the virtual routers in the group including those which are disabled individually,
you can use the same command with the enable all option as follows:
-> vrrp group 25 enable all
Note. Even though a virtual router may be assigned to a group, its parameter values and administrative
status can still be modified individually.
To Next Page
Loading...
