AVLAN Configuration Overview Configuring Authenticated VLANs
page 36-6 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
6 Enable authentication by specifying the authentication mode (single mode or multiple mode) and the
server. Use the RADIUS or LDAP server name(s) configured in step 5. For example:
-> aaa authentication vlan single-mode rad1 rad2
7 Set up an accounting server (for RADIUS or LDAP) for authentication sessions.
-> aaa accounting vlan rad3 local
Note. Verify the authentication server configuration by entering the show aaa authentication vlan
command or verify the accounting server configuration by entering the show aaa accounting vlan
command. For example:
-> show aaa authentication vlan
All authenticated vlans
1rst authentication server = rad1,
2nd authentication server = ldap2
-> show aaa accounting vlan
All authenticated vlans
1rst authentication server = rad3,
2nd authentication server = local
For more information about these commands, see the OmniSwitch CLI Reference Guide.
To Next Page
Loading...
