Configuring QoS Creating Policies
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 40-41
Using applied l3 policies
Classify L3:
*Matches rule ‘r1’: action a1 (drop)
In this example, the display indicates that the switch found an applied rule, r1, to classify Layer 3 flows
with the specified source and destination addresses.
To activate any policy rules that have not been applied, use the qos apply command. To delete rules that
have not been applied (and any other QoS configuration not already applied), use the qos revert
command. See “Applying the Configuration” on page 40-54.
To Next Page
Loading...
