Rockwell Automation Publication 750-UM006C-EN-P - March 2022 75
Configure and Start Up the Drive Chapter 4
6. On the Motor Data step, enter the Motor Nameplate data. Click Next.
This information is found in the Prepare for Initial Drive Startup
on
page 49 table.
7. On the Stop Mode step, enter the desired stop/brake mode along with
the dynamic brake resistor data collected before startup. Click Next.
IMPORTANT If customer supplied protection is to be used in place of the calculated
resistor thermal protection for the drive, set the [DB ExtPulse Watts] to its
maximum value.
To Next Page
Loading...
