Ametek Sorensen Asterion AST Series - Calibration and Verification Procedures; Calibration Introduction and Interface Types

M330460-01 Rev AB 4-1
4
CALIBRATION AND VERIFICATION
4.1 Introduction
This section provides calibration and verification procedures for the DC Asterion Series
power supplies.
4.1.1 Calibration and Verification Cycle
Annual calibration and verification is recommended. Calibrate only as needed.
4.1.2 Digital programming and readback calibration
Refer to the DC Asterion programming manual for calibration of display readback and
remote digital programming.
4.1.3 Analog control interface calibration (Standard and Isolated analog
interface)
The analog control interface calibration requires opening of the chassis top cover and it
should be carried out by service personnel only. Contact repair and maintenance service
department for the same.