Ametek Sorensen Asterion AST Series - Figure 3-26. Current Ramp-Screen (SW Trigger)

DC Asterion Series Overview
M330460-01 Rev A 3-13
Figure 3-26. Current Ramp-Screen (SW Trigger)
Waiting for Trig This field is displayed after Initialize button is pressed in HW trigger
Mode, refer to Figure 3-27. This shows that the supply is waiting for
an active high pulse of 10ms on the MOLEX connector pin-8
(TRIGGER_IN) and pin-12 (DIN_RTN) to generate the Current
Ramp. Refer to Table 3–2. Analog Programming Connector,
Designations and Functionsfor PIN details.
Figure 3-27. Current Ramp-Screen (HW Trigger)
Abort In SW trigger mode, when Trigger Ramp button is pressed, it
changes to Abort button.
In HW trigger mode, when external trigger is received, Waiting for
Trig will change to Abort button, refer to Figure 3-28. Pressing the
Abort button aborts the ramp.
Figure 3-28. Current Ramp-Screen (Abort)
Exit Exits the Current Ramp sub menu and return to Ramp Screen Top
level menu, refer to Figure 3-19.
NOTE: You cannot exit out of Current Ramp Screen using HOME and UP arrow, these
buttons are disabled for the Current Ramp Screen; Refer to Figure 3-25.