Overview DC Asterion Series
3-34 M330460-01 Rev A
Factory Default Sets the Power supply settings and values to its Default. This also
resets the Remote Analog Programming settings to its default
status. A confirmation window will pop-up when Factory Default is
pressed. The power supply will reset to its default after user
confirmation. Refer to Figure 3-89.
NOTE: This will not reset LAN configuration
Figure 3-89. System Settings Screen (Factory Default)
Parallel Resets the Parallel Chassis connection. Refer to Figure 3-90.
Chassis Reset
Figure 3-90. System Settings Screen (Parallel Chassis Reset)
3.1.9 Warning/Fault Screen
The following warning/Fault screen may appear during operation Refer to Figure 3-91:
Pressing on View Faults will display all the Fault/Warning description with an option to
clear the Fault.
These warnings indicate description of Faults which has occurred in a power module,
such as an overtemperature, under voltage of AC input, or converter failure etc. These
conditions might clear themselves, however, if they continue to occur after pressing
the clear Fault, contact the factory for service assistance. Refer to Figure 3-92.
To Next Page
Loading...
