WARNING!
This unit is intended for installation in a protected environment. Exposure to
conductive contaminants or corrosive compounds/gases that could be ingested into
the chassis could result in internal damage. Install the power source in a
temperature and humidity controlled indoor area.
2.4 Rack Mounting
The Asterion DC Series power source is designed for mounting in a standard 19-inch
equipment rack that is compliant to ANSI/EIA-310-D. If other instrumentation is
mounted in the rack adjacent to the unit, there is no need for additional clearance
above or below the source. It should be supported in the rack using appropriate L-
brackets or rackmount slides. Refer to Figure 2-1 for typical rackmount installation.
Recommended rackmount kits are as follows:
1. Rackmount Slide Kit (Option): AMETEK part number 5330201-01R.
2. Rackmount Flange Bracket Kit (Option): AMETEK part number 5330241-01R.
Install the rackmount kit as follows:
1. Install the slide sections, 1 , on both sides of the power supply chassis with
screws, 6 , (three on each side).
2. Install the brackets, 4 , to the stationary slide sections, 3 , with screws,
6 , and nuts, 5 , (four on each side).
3. Adjust the location of the mounting brackets as required for the particular type
of rack cabinet vertical rails utilized.
4. Mount the stationary slide sections, 3 , (with brackets already installed) into
the cabinet using appropriate hardware (e.g. the screws and nuts supplied, 8
and 7 , or user-supplied bar-nuts, cage-nuts, clip-nuts), while ensuring that
they are level, front to back and left to right, on the cabinet rails.
To Next Page
Loading...
