1. Before switching on, check the defibrillator monitor for mechanical damage, and
whether the pads, external cables, and accessories are properly connected.
2. Plug the power cord into an AC power outlet. If using battery power, ensure that the
battery has sufficient power; if using DC power, the inverter provided by our company must be
used.
3. Rotate the mode selector switch to enter the desired operating mode. A self-test
screen will be displayed on the screen after switching on, and it will prompt OK after completing
the self-test.
4. Once the start-up screen disappears, the Defibrillator Monitor enters the selected
operating mode screen.
Warnings
If the Defibrillator Monitor is damaged or not working properly, it must not be used for
patient monitoring and treatment. Please contact service personnel immediately.
3.1.5 Start Using the Device
1. Check the Patient’s condition and confirm what monitoring or treatment is needed.
2. Check that the patient cables and sensors are correct.
3. Connect that the patient cables and sensors are correct.
4. Enter the required operating mode and check whether the various settings of the
Defibrillator Monitor are correct.
5. See the appropriate section for details on monitoring and treatment.
3.1.6 Power Off
Refer to the following steps to power off the defibrillator monitor:
1. Confirm that monitoring or treatment for patients has been completed.
2. Disconnect cables, leads, or pads from the patient.
3. Verify that the patient-related data has been saved or removed.
4. Turn the mode selection switch to the "OFF" position. The Defibrillator Monitor will be
powered off after 7 seconds.
To Next Page
Loading...
