Amsco C Series - 5.6.1 Values Touch-Screen Pads

5-9
Component Identification Operator Manual P129394-176
5.6.1 Values Touch-Screen
Pads
The values touch-screen pads are accessed through the MENU
screen by pressing CHANGE CYCLE VALUES (refer to Figure 5-7).
These pads are used for changing the operating values used in
cycles, changing the cycles displayed on the cycle selection menus
and for changing the operating settings of the sterilizer. Instructions
for changing sterilizer cycle parameters are in Section 7, Cycle and
Control Value Programming.
Figure 5-7. Values Touch-Screen Pads
SELECT VALUE TO CHANGE.
1 TEMP STER DRY
NAME 000 F 00M 00M
11
MENU
Press this
button to
change a cycle
name
Press this
button to
change
sterilization
exposure time
(limited range)
Press this
button to
change drying
time
CUSTOM NAME 1
CUSTOM NAME 2
Press this button
to change
sterilization
exposure
temperature
(limited range)
Press either of
these buttons to
enter a user
defined cycle
name