Amsco C Series User Manual

7-14
P129394-176 Operator Manual Cycle and Control Value Programming
4. If the Access Code is already enabled and ACCESS CODE
touchpad is pressed at the Change Machine Setup screen
(#20), the display advances to screen #37 and the control
prompts the user to enter the Access Code.
a. Enter Code using the touchpads at the right of the screen.
b. Once the Code has been entered, press the ENTER
touchpad to advance to Select Access Code screen (#21).
5. If the status of the Access Code does not need to be changed,
press EXIT to return to the Change Machine Setup screen (#20).
Entering the Access
Code, Once Enabled
Once the Access Code has been set, any locked out functions or
cycle values are protected from unauthorized access. If any of these
locked out functions are selected, screen #37 appears on the
display.
1. If the code is known, enter it using the touch-screen key pad.
Once the entire four-digit code has been entered, press the
ENTER touchpad. The access code digits are not displayed.
2. If the code is not known, press CANCEL to return to the previous
screen.
7.5.2 Lockout This function is used to protect selected setup options from changes
by unauthorized personnel. Any functions selected for lockout
cannot be accessed without first entering the correct Access Code.
Items can also be unlocked at this screen. Small lock graphics
displayed in upper left hand corner of each touchpad indicate if item
is locked or unlocked. ( =unlocked, =locked.)
1. To access this utility:
a. Press MENU touchpad from the Status screen (#1) at the
operating end of the sterilizer.
b. The screen changes to show the Menu screen (#2).
c. Press the CHANGE MACHINE SETUP touchpad, the
display changes to the Setup screen (#20).
AN ACCESS CODE IS REQUIRED!
ENTER ACCESS CODE
OR PRESS CANCEL TO
RETURN TO MENU.
ENTER
MENU
1 2 3
4 5 6
7 8 9
<- 0 ->
37

Amsco C Series Specifications

General

Brand	Amsco
Model	C Series
Category	Laboratory Equipment
Language	English