7-23
Cycle and Control Value Programming Operator Manual P129394-176
7.5.7 Machine Number This set up is used to enter an identifying, two-character code into
the sterilizer control. This code can be letters, numbers or a
combination of both. The Machine Number code is printed out in the
header for each cycle, allowing for processed goods to be traced
back to a specific sterilizer when needed. If this option has been set
to a value between 1 and 9, cycle complete tone sounds the set
number of times.
1. To access this feature, press the MENU touchpad at screen #1:
at screen #2 press Change Machine Setup. The display
advances to screen #20.
2. At screen #20, press MACHINE NUMBER touchpad; the display
advances to screen #41.
3. At screen #41, enter the two-character code for the sterilizer.
Any letter, number, or combination can be used as the machine
number. Ensure however, that each machine number used is
different from any others that have been used in the facility.
NOTE: Dash and space touchpads have been provided.
4. Once the machine number has been entered, press EXIT to
return to screen #20.
7.5.8 Time Format This setup option allows the operator to select the “format” for the
time. The format determines how hours and minutes are displayed.
There are two options — the default format shows time in the military
format (referred to as 24 HOUR); the optional format shows time in
AM/PM format.
1. To access this utility, press MENU touchpad from the main
status screen (#1) at the operating end of the sterilizer. The
screen changes to show the Menu screen (#2). Press CHANGE
MACHINE SETUP touchpad, the display advances to screen
#20.
2. At screen #20, press TIME FORMAT touchpad. The display
advances to screen #30.
ENTER MACHINE NUMBER
MACHINE NUMBER = VAC 00
41
A B C D E 1 2 3
F G H I J 4 5 6
K L M N O 7 8 9
P Q R S T <- 0 ->
U V W X Y
EXIT
Z _ SPACE
To Next Page
Loading...
Need help?
General
