7-24
P129394-176 Operator Manual Cycle and Control Value Programming
3. Select the appropriate time format by pressing one of the two
touchpads in the lower half of the display.
• AM / PM – This is the standard civilian time format.
• 24 HOUR – This is a 24 hour format associated with military
timekeeping.
4. Once the appropriate format has been selected, or if format
does not need to be changed, press EXIT to return to the
Change Machine Setup screen (#20).
7.5.9 Print Format This setup option allows the operator to select the cycle printout
“format.” The format determines the type of printout the sterilizer
provides during processing. Two options are available. The default
FULL format provides status prints at each transition point in the
cycle, plus additional status at interval points during each phase of
the cycle. The optional CONDENSED format provides a cycle
summary and complete time, without additional status prints at cycle
interval points. The CONDENSED format can be used to conserve
printer paper. Refer to Figure 7-6.
1. To access this utility, press the MENU touchpad from the Status
screen (#1) at the operating end of the sterilizer. The screen
changes to show the menu screen (#2). Press the CHANGE
MACHINE SETUP touchpad.
2. Press PRINT FORMAT touchpad on the Change Machine Setup
screen (#20); the display advances to screen #29.
SELECT TIME FORMAT
AM/PM 24 HOUR EXIT
30
To Next Page
Loading...
Need help?
General
