6-19
Sterilizer Operation Operator Manual P129394-176
6.12 SFPP Sterilizer
Cycles
AMSCO C Series SFPP Steam Sterilizers are shipped with factory-set
cycles. The cycle sequence for these cycles is given in S
ECTION 6.13
(prevac and gravity cycles are described in S
ECTION 6.9, SECTION
6.10 and SECTION 6.11). Refer below, and to Table 2 (page iii) for
factory-set, qualified cycle settings.
Important: Applicable cycles have been validated to satisfy the
requirements outlined in Table 4-1 and Table 4-2. If cycle
parameters (sterilize time, dry time, temperature) other than those
listed are required, it is the responsibility of the healthcare facility to
consult and follow the device manufacturer’s written instructions.
NOTE: Contact your customer service representative for information
on a wide range of education/training programs designed to meet the
educational needs of healthcare industries.
To Next Page
Loading...
Need help?
General
