7-4
P129394-176 Operator Manual Cycle and Control Value Programming
Once all values for the selected cycle have been adjusted, press
EXIT to save new values and return to the cycle selection display.
Upon leaving Change Values the control prints the changed cycle
values.
7.2.3 Step by Step Flowchart
Figure 7-1. Accessing Change Cycle Values, Part 1 of 3
IMPORTANT:
Applicable cycles have been
validated to satisfy the
requirements outlined
in Table 4-1 and Table 4-2. If
cycle parameters (sterilize
time, dry time, temperature)
other than those listed are
required, it is the responsibility
of the healthcare facility to
consult and follow the device
manufacturer’s written
instructions.
7-2
To Next Page
Loading...
Need help?
General
