Anilam Wizard 900 - Page 110

104
Advanced (ADV) Functions Key (Continued)
To enter the diameter of the tool or edge sensor probe – for example, .25 in. (6.35 mm):
3. Press
ENT
The DRO turns off the axis displays and displays the following in the message window:
Home
pos
4. Move to the machine home position.
5. Press
ENT
The DRO displays the following in the message window:
Xi
pos
6. Move to position 1 and touch the workpiece with the tool or edge sensor probe.
7. Press
ENT
The DRO displays the following in the message window:
X2
pos
8. Move to position 2 and touch the workpiece with the tool or edge sensor probe.
9. Press
ENT