Section 5 Status Messages
5-16
5.5.2 Bit definition of ERR event status register
The following describes the operation of the ERR event status register model, the
naming of its event bits, and what they mean.
disabled = 0, enabled = 128(2
7
)
disabled = 0, enabled = 64 (2
6
)
disabled = 0, enabled = 32 (2
5
)
disabled = 0, enabled = 16 (2
4
)
disabled = 0, enabled = 8 (2
3
)
disabled = 0, enabled = 4 (2
2
)
disabled = 0, enabled = 2 (2
1
)
disabled = 0, enabled = 2 (2
0
)
7
6
5
4
3
2
1
0
7
6
5
4
3
2
1
0
&
&
&
&
&
&
&
&
Logical OR
ERR Event Status Enable Register
Set by ESE3 <n>
Read by ESE3?
Read by ESR3?
Not used
RX Measure measurement error (rxmstat)
TX Measure measurement error (mstat)
Execution error
Not used
ERR Event Status Register
ESB summary message bit
(To bit 3 of the status byte register)
The ERR event status register selects whether the register makes the summary mes-
sage true when the corresponding bit of the status register is set.
Bit Event name Description
7 (Not used) (Not used)
RX Measure measurement error
(rxmstat)
This bit is set to 1 when CDMA reception measurement error is
occurred.
TX Measure measurement error
(mstat)
This bit is set to 1 when CDMA transmission measurement error
or analog measurement error is occurred.
6 (Not used) (Not used)
5 (Not used) (Not used)
4 (Not used) (Not used)
3
2
1 Execution error
This bit is set to 1 when execution error is occurred at Zero Set,
Adjust Range, or Manual Calibration.
0
(Not used) (Not used)
Note:
Sweep or measurement error means other than the three states of normal end,
sync established, and not measured.
To Next Page
Loading...
