Anritsu MT8801C - CDMA Transmitter and Receiver Test; Preparations; TX and RX Tester Mode

Section 4 Operation
4-16
4.3 CDMA Transmitter and Receiver Test
--- TX and RX Tester Mode
This paragraph describes operation using the MT8801C Option 12 CDMA Measure-
ment to measure the CDMA transmitter and receiver.
4.3.1 Preparations
This paragraph describes the setup, zero-point calibration of the power meter, and RF
cable loss correction when measuring the DUT.
(1) Setup
This paragraph explains how to set the MT8801C and device under test (DUT)
when conducting tests.
[DUT Interface connector]
The DUT Interface connector is equipped on the bottom of the MT8801C front
panel to transmit and receive signals for control and measurement.
The following lists the specifications and functions of the DUT connector and
gives and notes on its use.