Anritsu MT8801C - Device Initialization by the *RST Command

6-5
6.4 Device Initialization by the ∗RST Command
6.4 Device Initialization by the ∗RST Command
■ Syntax
∗RST
■ Example
PCall ibwrt(ud%,"*RST"):
Initializes the device (MT8801C) whose address is 1 with level 3.
■ Explanation
The ∗RST(Reset) command is an IEEE488.2 common command which resets a de-
vice with level 3.
The ∗RST(Reset) command is used to reset a device (MT8801C) to a specific initial
state. Refer to the separate Operation Manual Vol. 1 Appendix B for details of initial-
ization items and initial values.
Note:
The ∗RST command does not affect the items listed below.
[1] IEEE488.1 interface state
[2] Device address
[3] Output Queue
[4] Service Request Enable register
[5] Standard Event Status Enable register
[6] Power-on-status-clear flag setting
[7] Calibration data affecting device specifications
[8] Parameters preset for controlling external devices, etc.