Anritsu MT8801C - Maintenance Commands

2-43
2.5.10 Maintenance commands
Maintenance Mode Maintenance TESTMODE TESTLOOPBACK TESTMODE? TESTLOOPBACK *1
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Mode On
Maintenance TESTMODE? NONE *1
Mode Off
Pilot Channel Pilot channel Pilot Channel Only TESTPILOTCH ON TESTPILOTCH? ON *2
Output On
Pilot channel
TESTPILOTCH OFF TESTPILOTCH? OFF *2
Output Off
Note 1:
*1 Moves from Idle state to Test Mode (Loop Back) state.
Valid only in CDMA mode with Idle state of Call Proc after Start execution
on Setup Common Parameter screen.
*2 Sets SG output only from Pilot Channel.
Valid only at Test Mode (Loop Back) state.
Note 2:
The usable measurements in the Test Mode of Loop back are the Modulation
Analysis and Power Meter.
Cannot move to the RF Power screen, Open Loop Time Response screen, and
Frame Error Rate screen.
Re-
marks
Query Msg
Intermediate
class
Function Program Msg Response MsgFunction details
2.5 Device Message List