Section 2 Device Messages
2-42
(2) Call Processing Status screen commands
• Program Msg of the Call Processing Status commands are valid only at Setup Com-
mon Parameter screen.
Query Msg of the Call Processing Status commands are valid at all the screens of
the TX/RX measurement screens.
Status Start CALLSA --- ---
Stop CALLSO --- ---
Register CALLREG --- ---
NW Originate (Paging) CALLPG --- ---
NW Relase CALLNWR --- ---
Refresh Call Status CALLRFR --- ---
Result Call Processing Status --- CALLSTAT? ss *1
Call Processing Error --- CALLERR? ss, ec *1, 2
Call Processing Result ---
CALLRSLT? ss
flg, ec *1, 2, 3
Note:
*1 Meaning of response Data → ss: 0-255 (0-14: Valid)
*2 Meaning of response Data → ec: (Error Code) 0, 1-255
*3 Meaning of response Data → flg: (Executed flag) 0,1
* Meaning of Response data
ss (Sequence) 0:Stop, 1:Idle, 2:Idle (Regist), 4:Registration, 5:Origination,
6:Termination, 7:Conversation, 8:Handoff, 9:NW Release,
10:MS Release, 12:Other, 13:Loop Back
flg (Received flag) 0:Not received, 1:Received (When Received flag is 0, then
other data are set to 0.)
ec (Error code) 0:No error, 1 to 255:Error code
RemarksQuery Msg
Intermediate
class
Function Program Msg
Response
Msg
Function
details
To Next Page
Loading...
