Anritsu MT8801C - Preparations before Power-On

2-5
2.3 Preparations before Power-on
2.3 Preparations before Power-on
The MT8801C operates normally when connected to 100 to 120 Vac, 47.5 to 63 Hz, or
200 to 240 Vac, 47.5 to 63 Hz AC power supply via the power inlet.
To prevent the following problems, take the necessary procedures described on the
following pages before power is supplied.
• Accidental electric shock
• Damage caused by abnormal voltage
• Ground current problems
To protect the operator, the following WARNING and CAUTION notices are at-
tached to the rear panel of the MT8801C.
CAUTION
WARNING
Disassembly, adjustment,
maintenance, or other access inside
this instrument by unqualified
personnel should be avoided.
Maintenance of this instrument
should be performed only by Anritsu
trained service personnel who are
familiar with the risks involved of fire
and electric shock.
FOR CONTINUED FIRE
PROTECTION REPLACE
ONLY WITH SPECIFIED
TYPE AND RATED FUSE.
CAUTION
Replace only with fuses of the
specified type and rating. The use of
improper fuses may cause fire.
NO OPERATOR SERVICE-
ABLE PARTS INSIDE.
REFER SERVICING TO
QUALIFIED PERSONNEL.