Anritsu MT8801C - Section 6 Initial Settings

6-1
Section 6 Initial Settings
This section outlines initialization for the system and describes how to initialize the
system.
An example of initial settings are written for IBM-PC commands.
6.1 General Description ................................................... 6-2
6.2 Bus Initialization by the IFC Statement ..................... 6-3
6.3 Initialization for Message Exchange by DCL and
SDC Bus Commands ................................................ 6-4
6.4 Device Initialization by the *RST Command ............. 6-5
6.5 Device Initialization by the PRE/INI/IP Command .... 6-6
6.6 Device Status at Power-on ........................................ 6-7