Anritsu MT8801C - Section 5 Measurement Examples

5-1
Section 5 Measurement Examples
This section describes the measurement procedures to perform the performance test of
the CDMA mobile station using the MT8801C.
5.1 Preparation for the CDMA Mobile station
Measurement............................................................. 5-2
5.1.1 Connecting the CDMA mobile station and
MT8801C ....................................................... 5-2
5.1.2 Setting MT8801C and the CDMA mobile
station ............................................................ 5-3
5.2 Testing CDMA Mobile station Output ........................ 5-7
5.2.1 Analyzing modulation .................................... 5-7
5.2.2 Measuring open loop output power .............. 5-9
5.2.3 Measuring open loop time response ............. 5-12
5.2.4 Measuring maximum RF output power ......... 5-15
5.2.5 Measuring minimum output power ................ 5-17
5.2.6 Measuring gated power................................. 5-18
5.2.7 Measuring TX spurious closed to fc .............. 5-20
5.2.8 Measuring TX spurious points ...................... 5-22
5.2.9 Measuring occupied bandwidth .................... 5-24
5.2.10 Measuring access probe output power ......... 5-26
5.2.11 Measuring standby output power .................. 5-29
5.3 Testing CDMA Mobile station Input........................... 5-31
5.3.1 Measuring frame error rate under AWGN ..... 5-31
5.3.2 Measuring RX sensitivity ............................... 5-33
5.3.3 Measuring dynamic range ............................. 5-35