Section 4 Operation
4-56
4.3.6 CDMA Transmitter Measurement
On the Setup Common Parameter screen; set the Control Band to C800 MHz, C1.9 GHz,
or C1.7 GHz; and press the [TX Measure] F1 main function key to set CDMA trans-
mitter measurement mode.
This paragraph describes the following CDMA transmitter measurement items:
1. Setting the parameters (Setup TX Measure Parameter screen)
2. Modulation analysis (Modulation Analysis screen)
3. Gated output power measurement (Gated Power screen)
4. Setting the template (Setup Template screen)
5. Power meter (Power Meter screen)
6. Standby Output Power measurement (Standby Output Power screen)
7. Access Probe output power measurement (Access Probe Measure screen)
8. Open Loop Power Control Time Response measurement (Open Loop Time Re-
sponse screen)
9. Measuring the occupied frequency bandwidth (Occupied Bandwidth screen)
10. Spurious close to the Carrier measurement (Spurious close to the Carrier screen,
Setup Spurious Template screen)
11. Spurious measurement (Spurious Emission screen, Setup Frequency Table
screen)
To Next Page
Loading...
