Anritsu MT8801C - Screen Descriptions

4-7
4.2 Screen Descriptions
This paragraph describes the common items displayed on the screen.
(1) Screen layout
The composition of the measurement screen is described below.
• Title display area The type MT8801C, and date (**_**_**) time (**:**:**), or user-defined character
string (title) are displayed on the top left line. These are set on the Instrument Setup
Screen.
• Screen name display area The screen name (paragraph 3.2.2 (4)) and measurement system name CDMA are
displayed on the second line from the top left.
• Measurement error messages display area
Messages for errors generated during measurement are reverse displayed on the third
line from the top left.
There are 16 measurement error messages as follows. TX messages are shown in high
priority order.
[CDMA TX measurement]
RF input limit RF input level limit.
Level Over Level too high
Level Under Level too low
Unmeasurable Measurements cannot be carried out.
Short Code Not Found Short code undetectable
Time-out Time out
[CDMA RX measurement]
Time-out Time out
Upper Limited Error Upper-limit value error
Call Processing Error Call processing error
[Analog RF measurement]
Input Level Over RF input level out of hardware use limit
Level Over RF input level too high
Level Under RF input level too low
Deviation Under Deviation measured results too small
[Analog AF measurement]
Input Level Over RF input level out of hardware use limit
Level Over RF input level too high
Level Under RF input level too low
4.2 Screen Descriptions