ADVANCED OPERATION
36
Changing the Search Type
AR-mini has tree types searching
method. It can changed in searching.
1
Start the search.
2
Press the SCAN key to change the
scan type.
• The scan type is changed by each
pressing as follows;
Busy Search
➝ Hold Search ➝
Time Search ➝ Busy Search ➝ ·····
• Busy Search:
“B” icon is lit.
The search is paused while
receiving the signal. The search
is resumed 2 seconds later when
the signal is gone.
• Hold Search:
“B” icon is blinking
The search is stopped when the
signal is received.
• Time Search:
No icon is displayed.
The search is paused for 5
seconds when the signal is
received. The search is resumed
5 seconds later even if the signal
is received. Within 5 seconds,
the search is resumed 2 seconds
later when the signal is gone. This
pausing time can be changed in
setting mode.
Changing the Search
Band Memory
The search band memory is preset at
shipped. The frequency of search band
memory can be changed.
1
Start the limit search.
2
Hold down the FUNC key and turn
the dial knob to select the memory
number to be memorized.
3
Hold down the FUNC key and
press the SCAN key for 2 seconds
or more.
Tips:
The search band memories are
listed on page 74.
To Next Page
Loading...
