SETTING MODE
58
Setting the Memory for
the Memory Bank Link
Scan
This setting is used for setting memory
banks that are linked for a scan.
1
Display a memory bank to be
linked to another memory bank.
2
Hold down the FUNC key and
press the dial knob to select the
setting mode.
3
Turn the dial knob to set the
setting mode number 11.
4
Hold down the FUNC key and turn
the dial knob to select the memory
bank number to be linked for the
memory bank which is displayed in
step 1.
5
Press the dial knob.
• The bank link mark is displayed.
6
Press the dial knob to setting
mode.
7
To return the original display, press
the dial knob or V/M key.
Tips:
When the memory bank link is
canceled, repeat steps 1 through 5
and select the memory bank number
to be canceled and erase “.” (bank
link mark) by pressing the dial knob.
To Next Page
Loading...
