ATI Technologies QC-210 - SA2 Tool; SA3 Tool; SA4 Tool; SA5 Tool

Manual, Control and Signal Module, SA2 SA3
Document #9620-20-C-SA2 SA3-04
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati-ia.com • Email: info@ati-ia.com
C-4
1.3 SA2 Tool
The SA2 Tool module provides up to 19 pass-through signals. The customer interface connection is an
Amphenol 19-Pin MS-style connector. There is no Tool-ID.
1.4 SA3 Tool
The SA3 Tool module provides up to 19 pass-through signals. The customer interface connection is an
Amphenol 19-Pin MS-style connector. (10) unique Tool-ID values are available (0–9). The Tool-ID is tied
into 24 VDC from Pin B, refer to the details in Section8—Drawings.
1.5 SA4 Tool
The SA4 Tool module provides up to 19 pass-through signals. The customer interface connection is an
Amphenol 19-Pin MS-style connector. (100) unique Tool-ID values are available (0–99). The Tool-ID is tied
into 24 VDC from pin B, refer to the details in Section8—Drawings.
1.6 SA5 Tool
The SA5 Tool module provides up to 19 pass-through signals. The customer interface connection is an
Amphenol 19-Pin MS-style connector. (1000) unique Tool-ID values are available (0–999). The Tool-ID is
tied into 24 VDC from pin B, refer to the details in Section8—Drawings.
1.7 SA6 Tool
The SA6 Tool module is identical to the SA2 Tool module except that it is potted.
1.8 SA7 Tool
The SA7 Tool module provides up to 15 pass-through signals. The customer interface connection is an
Amphenol 19-Pin MS-style connector. (10) unique Tool-ID values are available (0–9). The Tool-ID is tied
into 0 VDC from pin A, refer to the details in Section8—Drawings.