Maintenance Focus 61 User Guide
9839 0211 01 Edition 2.0 110 (118)
NOTE: Pay close attention during the execution of the next steps: the two Miniature Fuses could
fall down on the floor. This is due to the fact that it is not necessary to remove the Focus 61 from
its working position.
4. Extract the Fuses Holder with a shaped tool (for instance a flat screwdriver).
5. There are two Miniature Fuses located into the Fuses Holder: remove the old Miniature Fuses and
install the new ones.
6. After installing the new Miniature Fuses, pushing the Fuses Holder into its housing.
7. Reconnect the power cable to the multifunctional power socket
NOTE: Use ONLY the power cable provided with the Focus 61 package. If you use any other
power cable, the protection provided by the equipment may be impaired.
8. Reconnect the power cable to the AC Power.
NOTE: Turn the Focus 61 on, to verify that fuses replacement was done correctly. Check, that
the light of the On/Off switch is red and the LEDs on the front panel illuminate correctly.
To Next Page
Loading...
