Atlas Copco FOCUS 61 - Page 45

Focus 61 User Guide Programming Focus 61
45 (118) 9839 0211 01 Edition 2.0
The Busy Wrenches are associated to other Focus 61 Controllers.
To make a Busy Wrench available, do the following:
1. Connect to the Controller the Wrench is linked to.
2. Unlink the wrench.
3. If the controller is off or disconnected, it is possible to unlink the wrench by right-clicking and
selecting Unlink Wrench:
NOTE: The Unlink Wrench option does not work if the associated controller is on and in radio
range.
NOTE: Be sure that the wrench is not in use on an other controller. If it is, it can cause
malfunctions.
In some case, a Busy Wrench is red highlighted (see the picture below). This means that the controller
has unlinked the MWR, but it has not received yet the command because it is out of radio range.