Focus 61 User Guide Programming Focus 61
47 (118) 9839 0211 01 Edition 2.0
The following commands are on the Pset Toolbar:
• Save
Use Save to save the Pset parameters.
• Export
Use Export to export the Pset in a .Pset file (formatted as xml).
• Import
Use Import to load the Pset from the .Pset file exported previously.
• Wrench
Serial numbers drop down list of the MWR linked to the Group.
• Start
Use Start to start a testing sequence with the assigned Pset on a MWR. The blue LED on the MWR
will start to flash, when the sequence is active.
Refer to the chapter Executing Tightening Operations for further details.
• Stop
Use Stop to stop the execution of the test sequence on the MWR.
• Live Monitor
Use Live Monitor to open the live results window. The
results are related to the MWR selected in the Wrench
field.
Refer to the paragraph Live Monitor for further details.
• Information
Use Information to get general information about the MWR
connected with the Focus 61.
After clicking Information, the Advanced Wrench Data dialog
box is displayed.
To Next Page
Loading...
