Atlas Copco FOCUS 61

Focus 61 User Guide Traces viewer
91 (118) 9839 0211 01 Edition 2.0
3. On the upper-left corner of the Traces viewer dialog box, click the Trace info icon ( ). The
traces available on the wrench are displayed in the Trace info workspace. The parameters
displayed for each trace are:
• ID
• Timestamp
• State
• Measurement mode
• Point count
4. From the list of the available traces, select up to five traces.
NOTE: It is not allowed select more than five traces.
5. On the upper-left corner of the Traces viewer dialog box, click the Download traces icon
( ).
NOTE: The Download traces icon becomes available after the trace to download are
selected.
6. Near the Trace info tab, click on of the tab to displayed the downloaded trace of interest.
To filter the available traces saved on the MWR:
1. In the ToolsTalk BLM toolbar, click Traces Viewer.
2. From the Available wrenches of the Traces viewer dialog box, select the necessary wrench.
3. On the upper-left corner of the Traces viewer dialog box, click the Trace info icon ( ). The
traces available on the wrench are displayed in the Trace info workspace. The parameters
displayed for each trace are:
• ID
• Timestamp
• State
• Measurement mode
• Point count
4. In the Trace filter section, set the following filter:
• Timestamp [from]…timestamp [to]: select the date by writing the date or by clicking the
calendar icon and selecting a date. It is possible set both the date (from and to) and only one
of them.
• States: from the dropdown list, select of the result state.
• Measurement method: from the dropdown list, select one of the following methods:
torque/angle, torque, angle, simulation.
5. On the right side of the Trace filter section, click Apply.