Atlas Copco FOCUS 61 - Page 92

Traces viewer Focus 61 User Guide
9839 0211 01 Edition 2.0 92 (118)
To stop the traces download:
1. In the ToolsTalk BLM toolbar, click Traces Viewer.
2. From the Available wrenches of the Traces viewer dialog box, select the necessary wrench.
3. On the upper-left corner of the Traces viewer dialog box, click the Trace info icon ( ). The
traces available on the wrench are displayed in the Trace info workspace. The parameters
displayed for each trace are:
• ID
• Timestamp
• State
• Measurement mode
• Point count
4. From the list of the available traces, select up to five traces.
NOTE: It is not allowed select more than five traces.
5. On the upper-left corner of the Traces viewer dialog box, click the Download traces icon
( ).
NOTE: The Download traces icon becomes available after the trace to download are
selected.
6. On the upper part of the Traces viewer dialog box, click the Stop download icon ( ).
To export the trace:
1. After a trace is downloaded, click the Trace tab ( ).
2. On the upper part of the Trace viewer dialog box, click the Export icon ( ). A file Excel is
created with all the points of the trace and all the parameters that characterize the trace.
To select the wrench of interest:
1. Select the wrench of interest from the Available wrench drop down list.