Atlas Copco PowerMACS 4000 User Manual

System Architecture
36 9836 3521 01
Setup Menu – IP Setup
The IP Setup is used to configure the IP addresses of the TC. PTC:s are equipped with two interfaces
(internal and external) whereas regular TC:s only have one interface (internal).
The following options can be set in IP Setup.
Menu
Description
IF 1 IP Address
IP Address for interface 1
IF 1 Net Mask
Net Mask for interface 1
IF 1 Gateway
Default gateway for interface 1
IF 2 IP Address
IP Address for interface 2 (PTC only)
IF 2 Net Mask
Net Mask for interface 2 (PTC only)
IF 2 Gateway
Default gateway for interface 2 (PTC only)
Note:
It is possible to lock the display from the system node in the system map in ToolsTalk PowerMACS. If the
display is locked it is not possible to use the display to make any changes. Instead of the text Change in
the Setup menus it will say Locked. It is still possible to look at all the information, but nothing can be
changed. To unlock the display you must connect with ToolsTalk PowerMACS change the setting in the
system map.
Info Menu
The Info menu contains information about the TC, press the Select button to go to either events or system
information.
Events: 1
Select Back
Select Back
Events Menu
Lists system events
System Information
Shows Information about TC
Sys info
Info Menu – Events

Atlas Copco PowerMACS 4000 Specifications

General

Brand	Atlas Copco
Model	PowerMACS 4000
Category	Power Tool
Language	English