Appendix
9836 3521 01 629
Step %d, Diagnostic: Calib. failed on T1. Meas. %f, expected %f
Step %d, Diagnostic: Incorrect configuration
Step %d, Check: Incorrect Peak torque
Step %d, Check: Incorrect Torque in angle window
Step %d, Check: Torque in angle window failed
Step %d, Check: Incorrect Torque in time window
Step %d, Check: Torque in time window failed
Step %d, Check: Incorrect Mean torque
Step %d, Check: Mean torque failed
Step %d, Check: Incorrect T/T3
Step %d, Check: T/T3 failed
Step %d, Check: Incorrect Angle
Step %d, Check: Angle failed
Step %d, Check: Incorrect Current
Step %d, Check: Incorrect Clamp Load
Step %d, Check: Incorrect Time
Step %d, Check: Incorrect Post view
Step %d, Check: Post view Torque failed
Step %d, Check: Post view Torque failed (Buffer overflow)
Spindle %d: Time for service. %d cycles since service (%d to
many)
Spindle: No program for mode %d
Cycle data too big, step %d not stored
Step %d, Monitoring: Final torque could not be evaluated
Step %d, Monitoring: Threshold angle could not be evaluated
Step %d, Monitoring: Torque rate could not be evaluated
(interval %d)
Step %d, Monitoring: Yield point torque could not be evaluated
Step %d, Monitoring: Yield point angle could not be evaluated
Step %d, Check: Peak torque. %f < %f
Step %d, Check: Torque in angle window. %f < %f
Step %d, Check: Torque in time window. %f < %f
Step %d, Check: Mean torque. %f < %f
Step %d, Check: Angle. %f < %f
To Next Page
Loading...
