Appendix
9836 3521 01 631
Step %d, Monitoring: Yield point angle diff. %f < %f
Step %d, Check: Torque rate %.4f > %.4f
Step %d, Check: Torque rate %.4f < %.4f
Step %d, Check: Deviation %f > %f
Step %d, Check: Torque Rate calculation failed
Step %d, Check: Overflow in Torque Rate recording buffer
Step %d, Check: Torque rate/deviation has bad configuration
Step %d, Retry is ordered but this step has no retry step
programmed
Step %d, Check: Angle failed because Torque stop was never
reached
Step %d, Monitoring: Torque level stop for Threshold angle was
never reached
Step %d, Control: Start cond. "Sync Pulse" requires Angle 2 as
control channel
Step %d, Received illegal Retry order in SP_RUN_STEPS from
station. (Spindle running %d.)
Step %d, Check: Peak torque failed.
Step %d, Diagnostic: Static Zero Offset high on T2. abs(%f) > %f
Step %d, Diagnostic: Dynamic Zero Offset high on T2. abs(%f) >
%f
Step %d, Diagnostic: Flying Zero Offset high on T2. abs(%f) >
%f
Step %d, Diagnostic: Flying Zero Offset high warning on T2.
abs(%f) > %f
Step %d, Control: Torque-Angle step has bad configuration
Step %d, Restriction: Start torque for FS Angle has bad
configuration
Step %d, Restriction: Start condition for FS Angle has bad
configuration
Step %d, Monitoring 2nd: Final torque could not be evaluated
Step %d, Monitoring 2nd: Threshold angle could not be
evaluated
Step %d, Monitoring 2nd: Final torque. %f > %f
Step %d, Monitoring 2nd: Threshold angle. %f > %f
Step %d, Monitoring 2nd: Final torque. %f < %f
Step %d, Monitoring 2nd: Threshold angle. %f < %f
To Next Page
Loading...
