Appendix
632 9836 3521 01
Step %d, Monitoring 2nd: Torque level stop for Threshold angle
was never reached
Monitoring 2nd buffer: No second channels. 2nd buffer used in
check %d, step %d.
Step %d, Restriction: Incorrect FS Min torque configuration
Step %d, Restriction: Incorrect Gradient restriction configuration
Step %d, Check: Incorrect Yield Point Check configuration
Step %d, Diagnostic: Spindle shunt test failed on channel %d
Step %d, Restriction: Fail-safe torque
Step %d, Restriction: Fail-safe angle
Step %d, Restriction: Fail-safe time
Step %d, Restriction: Cross thread and gradient
Step %d, Restriction: Torque profile
Double transducer: torque diff high
Double transducer: angle diff high
Monitoring: Overflow in recording buffer %d
Step %d, Servo hardware failure, Id %d
Incorrect Servo configuration
Step %d, Restriction: Remove fastener torque limit
Spindle protection: Max allowed torque for spindle exceeded
Step %d, Restriction: Min Torque
Step %d, Restriction: Gradient too high
Step %d, Restriction: Gradient too low
Step %d, Restriction: Gradient error as angle decreased
Step %d, Check YP: Gradient calculation restarted as angle
decreased
Step %d, Fatal continue rotation error, was not handled by reject
management
Step %d, Restriction error during continue rotation
Step %d, Continue rotation is not allowed at step start, spindle
was stopped
Step %d, Direction changed during Continue rotation
Trace: Unable to store new trace on TC %d, too many saved
traces
To Next Page
Loading...
