Appendix
9836 3521 01 633
Low battery voltage on TC %d
System TC on addr 0x%x received setup from other system TC
with addr 0x%x
TC %d received setup from 2 system TCs: 0x%x and 0x%x
TC %d Device type %d uses a serial channel, this is only
allowed on PTC
TC %d restarted due to fatal SW error (code: %s, sub code:
0x%x)
Printer on TC %d (port %d) does not support Device Command
= %d
ID write error %d on TC %d, port %d
ID read error %d on TC %d, port %d
ID read error on TC %d, port %d. Invalid start char. ASCII =
0x%x
ID read error on TC %d, port %d. Unable to read tag, Data = %d
ID write error on TC %d, port %d. Unable to write tag, Data = %d
ID device on TC %d, failed to write process data
ID read error on TC %d, port %d. Tot. length of string was more
than %d chars
ID read error TC %d, port %d. Start char was never received,
must be ASCII=0x%x
Device init. error (TC %d, device %d, info %d)
Illegal link message received (TC %d, device %d, info %d)
Device is not on a PLC TC (TC %d, device %d)
Missing sequence number (TC %d, device %d, expected seq.
no %d)
Received setup is too big (TC %d, device %d)
Device is not on the System TC (TC %d, device %d)
Fieldbus on TC %d has no contact with PLC
Fieldbus on TC %d can not read process data (err %d)
Fieldbus on TC %d can not write process data (err %d)
Fieldbus on TC %d can not read from board (err %d)
Fieldbus on TC %d can not write to board (err %d)
Fieldbus on TC %d rec. a req. (0x%x) that requires Data bytes
In >= %d
Fieldbus on TC %d rec. a req. (0x%x) that requires Data bytes
Out >= %d